Components, digital
bus
Every option, pin and variant of bus, as release
1.3.1
of the compiler states them.
Pins
bus with its default options, pins named.Pin functions
| Pin | Side |
|---|---|
bus | left |
out1 | right |
out2 | right |
A wire names a pin as ID.pin. Rotating the part moves the pins with it; their names stay the same.
Options
Options go in square brackets after the colour, as name=value. Any option not listed here is an error.
Options
| Option | Accepts | Default |
|---|---|---|
type | One of 3 values: tap,splitter,joiner | splitter |
inputs | Whole number from 1 to 32 | 1 |
outputs | Whole number from 1 to 32 | 2 1 when type=joiner |
orientation | One of 4 values: right,down,left,up | right |
fit | Only wires | None |
width | Whole number from 2 to 256 | 8 |
fit and orientation cannot be written together.
Variants
Pin names depend on the selected variant. Each drawing labels its own pins.
type=tap bus (left),tap (right)
type=splitter bus (left),out1 (right),out2 (right)
type=joiner in1 (left),bus (right)
Writing one
bus:U1 at (120, 112) #purple